Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 3, 2015 13:06:14 GMT -5
I hate to open this can again, but, just where should UTX [UT Europe, Canada] be placed in the FSX Library. It s pretty well set where to put Tongass in relation to Orx stuff. I heard the UTs should be below [highernumber] Orbx, A/P's etc. Any opinions ?? Carm. PS. somehow I just lost my 'water' all over the west coast. This is a common snag with me and the last time it happened I was going to write in my little red book what to do get me water back----but I forgot, but, I`ll do this time,  Once someone tells me again what is the cure  Thanks. |
|
|
|
Post by scottb on Sept 3, 2015 16:20:09 GMT -5
Mine show up just above Edwards_AFB and just below the ORBX Landclass files. I have most of it disabled now using Vector and Global, but it worked when I was using it. I'm not sure about the water issue, I've been fortunate not to have that issue. Yet  -Scott |
|
|
|
Post by olderndirt on Sept 3, 2015 20:40:21 GMT -5
As I recall when I had it, before Orbx, it never needed any special priority. Take a peek over at SimForums, they're the UTX folks.
|
|
|
|
Post by spud on Sept 3, 2015 23:44:46 GMT -5
I don't use UTX but reading the ORBX forums there are many references to having certain UTX files inactive and additionally the placement of the UTX entries in the scenery library when using it along with ORBX scenery.
|
|
|
|
Post by pivo11 on Sept 4, 2015 1:16:32 GMT -5
When I had UTX installed, the files were below all the Orbx stuff. As I recall, the UTX folders themselves needed to be layered in a certain way but I don't remember which way that was. Asking over at SimForums is probably a good idea. www.simforums.com/forums/forums.html (towards the bottom of the page) |
|
Once someone tells me again what is the cure 
